Toyota 84332-01070 Switch Assy, Hazard Warning Signal

You can Select Your Vehicle to check if 84332-01070 fits your vehicle.

To replace the hazard warning switch, start by disconnecting the negative battery cable. Carefully remove the center cluster finish panel from the instrument panel and pull the assembly out to disconnect the electrical connector at the rear of the switch. Use two screwdrivers to depress the switch retaining tangs and then remove the switch cluster from the panel, with installation being the reverse of removal. For the power mirror control switch and dimmer switch, locate the switches in a small panel to the left of the steering column, then carefully pry the panel from the dash with a trim tool. Disconnect the electrical connector and remove the switches, with installation following the reverse procedure. The rear window defogger switch is found in the heating and air conditioning control panel; remove the control panel and pull the assembly out to disconnect the electrical connector at the rear of the switch, then depress the tab to remove the switch from the bezel, with installation also being the reverse of removal.

For the hazard warning switch and rear window defogger switch replacement, remove the cable from negative terminal on the battery. Subsequently, make gentle extractions of the center finish panel of the instrument panel and also pull the assembly to disconnect the electrical connector at the rear part of the switches. Hold with one screwdriver at the holes as shown in picture #3 and turn the second screwdriver to compress the switch retaining tangs and pull out the switches, to install the switches reverse the process. As for the power mirror control switch and dimmer switch, these can commonly be found in a small panel to the left of the steering column; required steps will involve first carefully detaching this panel from the dash to access the electrical connector and then removing the switches, which will entail applying two screwdrivers to release the clips holding them in place; as for the reassembly of the switches, define the above given set of instructions in reverse.