Scion 90981-13046 Bulb

You can Select Your Vehicle to check if 90981-13046 fits your vehicle.

For fog lights, 2018 and later Sequoia and some Tundra models utilize LED fog lights that are not serviceable; if an issue arises, the entire assembly must be replaced. For halogen bulbs, disconnect the electrical connector, turn the bulb holder counterclockwise to remove it, and pull the bulb straight out for replacement, reversing the process for installation. For LED types, remove the bumper cover, take out the retaining clip, tape around the fog light cover's edge, and carefully pry up the cover to disengage clips before removing the fog light mounting bolts. Tundra models require removing a mounting screw and detaching the fog light from guides. Side marker and turn signal bulbs are located in the headlight housing; disconnect the electrical connector, turn the bulb holder counterclockwise to remove it, and pull the bulb straight out. For tail lights, Tundra models involve opening the tailgate, removing bolts, and rotating the housing for bulb access, while Sequoia models require opening the liftgate and removing screws to detach the housing. License plate lights on Tundra models involve removing screws for side-mounted lights or squeezing tabs for center-mounted lights, followed by turning the bulb holder counterclockwise to remove it. Sequoia models require removing retaining screws to detach the lens and pulling the bulb straight out. For high-mounted brake and cargo lights, remove screws to detach the lens for bulb access, pull out the defective bulb, and replace it. For dome lights, detach the lens and pull the bulb from the spring clips. Overhead personal light bulbs in Sequoia models require prying the lens out and pulling the bulb out for replacement. Installation for all components follows the reverse of removal.

Note that 2018 and later Sequoia models and some 2018 and later Tundra models use LED headlights, which are not serviceable; if there is a problem with an LED headlight, the entire headlight assembly must be replaced. First, unplug the electrical connector from the headlight bulb holder for both low beam and high beam. Next, if equipped, pull the rubber watershield off the bulb assembly. Then, turn the bulb body counterclockwise and remove it from the housing. Finally, installation is the reverse of removal.

Depress the release tab and disconnect the electrical connector from the high-beam headlight bulb socket.

Reach behind the headlight assembly and rotate the bulb holder counterclockwise to remove the bulb.

To remove the bulb socket from the headlight housing, you need to turn it counterclockwise and pull it out of the housing.

Pry off the outer cover of the side view mirror housing, remove the turn signal mounting fasteners, and rotate the bulb counterclockwise to remove it.

To remove the bulb socket from the headlight housing, you need to turn it counterclockwise and pull it out of the housing.

Carefully pry off the map light lens, pull the old bulb straight out, and push a new bulb straight into the housing until it stops.

Carefully pry off the lens using a small screwdriver.

After replacing the low-beam bulb, you should reinstall the round rubber cover over the low-beam bulb.

Plug in the electrical connector.

Pull the bulb straight out to replace it.

Remove the rubber cover over the bulb, then release the spring securing the headlight bulb and remove the bulb.

1. Remove the screws and detach the lens for bulb access. 2. Pull out the defective bulb. 3. Replace the bulb and install the lens and screws.

If equipped, pull the rubber watershield off the bulb assembly.

high beam and low beam 90981 13046 65 watts 90981 ad001 55 wats

NO ONLY SOLD WITH HEADLAMP ASSY.

YES