Toyota 12322-20020 Bracket, Engine Mounting, Rear

You can Select Your Vehicle to check if 12322-20020 fits your vehicle.

During the check, the engine must be raised slightly to remove the weight from the mounts.

Engine mounts seldom require attention, but broken or deteriorated mounts should be replaced immediately to prevent added strain on the driveline components, which may cause damage or wear.

The rear mount on V6 models has a different engine mounting bracket that cradles the insulator. It is retained by a through-bolt to the chassis bracket.

To check the engine mounts, you should raise the vehicle and securely support it on jackstands. Position a jack under the engine oil pan and place a large block of wood between the jack head and the oil pan. Raise the engine slightly to remove the weight from the mounts. Do not position the wood block under the drain plug. Then, visually inspect the mounts for signs of damage and use a large screwdriver or pry bar to check for any movement. If movement is observed, lower the engine and tighten the mount fasteners. Applying rubber preservative to the mounts can help slow down deterioration.