Toyota 90919-A5002 Sensor, Cam Position

You can Select Your Vehicle to check if 90919-A5002 fits your vehicle.

On V6 models, the two Camshaft Position Sensor are located on the inside walls of the cylinder heads. To remove it, take off the drivebelt and left timing belt cover, disconnect the CMP sensor electrical connector and remove the bolt and stud. The CMP sensor is also located on the front of the left cylinder head. To remove it, remove the engine cover, followed by disconnecting the CMP sensor electrical connector and removing the retaining bolt and sensor from the driver's side valve cover. Installation is the reverse of removal.

There are four CMP sensors on 2011 and later models.

On V6 and 2UZ-FE V8 engines, the CKP sensor should be disconnected by disconnecting the electrical connector.