Toyota 90311-89013 Seal, Type T Oil

You can Select Your Vehicle to check if 90311-89013 fits your vehicle.

Remove the engine/transaxle assembly and separate the transaxle from the engine. Remove the flywheel or driveplate and pry the Crankshaft Seal from the engine's rear, noting its depth for new seal installation. Clean the seal bore thoroughly. Lubricate the new seal's outside diameter and install it over the crankshaft end, ensuring the seal lip points towards the engine. Use a seal installation tool to press the new seal into place. If unavailable, use a large socket or blunt tool to drive the seal into the bore. Reinstall the flywheel or driveplate, reattach the transaxle to the engine, and reinstall the assembly.

The first step is to remove the engine/transmission assembly from the vehicle.

Install the flywheel or driveplate.

Wrap tape around the tip of the screwdriver to avoid scratching the housing bore or damaging the crankshaft, as this could cause the new seal to leak.

The remainder of the installation is the reverse of the removal process.

Run the engine and check for oil leaks at the front seal.

The new seal should be evenly driven into the container using a wood block or a section of pipe slightly smaller in diameter than the outside diameter of the seal.

Reinstall the crankshaft pulley, tightening the bolt to the specified torque.

Install the transaxle to the engine.

Clean the bore in the engine and coat the outer edge of the new seal with engine oil or multi-purpose grease. Apply the same grease to the seal lip.

The new seal can be driven into place using a seal driver or a large socket and a hammer. It is important to ensure that the seal enters the bore squarely and stops when the front face is at the proper depth.

Lubricate the pulley hub with clean engine oil and reinstall the crankshaft pulley.

Apply clean engine oil or multi-purpose grease to the outer edge of the new seal.

Yes, the seal can be replaced without removing the oil pan or seal retainer.

Lubricate the outside diameter of the seal and install the seal over the end of the crankshaft, ensuring the lip of the seal points toward the engine. Preferably, use a seal installation tool to press the new seal back into place. If the proper tool is unavailable, use a large socket, section of pipe, or a blunt tool to carefully drive the new seal squarely into the seal bore and flush with the edge of the engine block.